Ring Manufactures?

Discussion in 'Tech Questions' started by dlgerard, Aug 10, 2009.

  1. dlgerard

    dlgerard Member

    Joined:
    Feb 3, 2006
    Messages:
    55
    Likes Received:
    0
    We are looking for a ring that will provide some reasonable life and good sealing for:

    C&A 4.155 SBC light weight, gas ported, 3 rings [.043x.0625x3MM], Compression height = 1.025”, compression ratio = @15.0/1

    Any suggestions, besides Total Seal?

    DG
     
  2. Eric David Bru

    Eric David Bru New Member

    Joined:
    Dec 9, 2006
    Messages:
    37
    Likes Received:
    0
    Check out the Hell Fires by Sealed Power...

    EDB
     
  3. Ed Urcis

    Ed Urcis Member

    Joined:
    Nov 5, 2006
    Messages:
    192
    Likes Received:
    0
    rings

    The feedback I have gotten on the hellfire style rings is that they usually take longer to seat/break in than a std molly ring. Unless you are using nitrous,nitro, or some other power adder (which would indicate the use of a hellfire style ring) I think you would get very good resuls with a good quality molly ring. Ed

    PS- if you need help finding a source, I could help you out as I am employed at CP Pistons and these are in stock items. 949-567-9015 is my direct line there
     
    #3 Ed Urcis, Aug 14, 2009
    Last edited: Aug 14, 2009

Share This Page